Specifications

Hull and Deck

• Lloyd's approved, ABS inspected and certified, Baltek Contourkore end grained balsa laminate construction using biaxial and unidirectional glass with interplastic vinylester resin on the outer hull layer to permit a 10 year warranty against blistering.

• Lead & antimony fixed 4,500 lb. 6.5' draft, variable chord, high lift, fin keel bolted and epoxy bonded to deep molded stub.

• Contrasting non-skid on deck of smoke white, Seattle grey, or ivory on white.

• Double tapered boot stripe.

• ORC 1.5" teak foredeck toerail.

• Hull to deck joint bonded with 3M 5200, bolted on 4" centers.

• Large cockpit locker to port on cockpit seat and additional locker aft.

• Two molded instrument pods P & S of helmsman's station.

• Low maintenance stainless steel handrails on cabin trunk.

• Molded spray shield dodger storage area.

• GRP molded main structural bulkhead, glassed fore & aft to hull and deck as support for shroud chainplates, keel, hull, deck, and mast step (a unique and important feature of all J-Boats).

• All partial bulkheads glassed to hull and deck for more stiffness.

• Custom fabricated aluminum mast step with transverse beams forward and aft through bolted to GRP support beams.

• Heavy duty solid and independent transverse glass support beams over keel for maximum hull stiffness.

Propulsion and Steering

• Yanmar 3GM30 28 h.p. 3 cylinder diesel engine with fresh water cooling, Racor fuel filter, and 50 amp alternator.

• Yanmar engine instrument panel recessed in cockpit with tachometer, fuel gauge, alarms for oil pressure and temperature, and night lighting.

• Balanced spade rudder with unidirectional glass and large diameter molded shaft mounted in custom fabricated rudder bearing system to exceed ABS requirements.

• Edson 40" Destroyer wheel on custom molded super strong pedestal with 5" Ritchee compass, brake, and stainless guard. Gear ratio of 1:1 to facilitate installation of self steering devices.

• 21 gallon alloy fuel tank with baffles and inspection/clean out port located in aft quarter cabin.

• Aluminum anodized emergency tiller.

• Martec folding propellor with 1" Aquamet stainless engine shaft.

Plumbing

• Marelon seacocks and double clamped hoses below the waterline.

• Manually operated bilge pump in cockpit.

• Automatic electric bilge pump with switch between pump and independant of main panel.

• Manual fresh water system with foot pumps in the head and galley.

• 65 gallons standard water capacity in two, independantly valved polyurethane tanks with baffles which are secured by nylon strapping to exceed ABS regulations.

• Raritan PH-2 head with 18 gallon holding tank and Y' overboard discharge.

• Ice box drain with valve.

Deck Hardware

• Two Barient 27 STA (self tailing aluminum) 2-speed primary cockpit winches.

• Two Barient 21 STA 2-speed winches (on aft cabin trunk) with Lewmar stoppers for main and jib halyard, two tack reefs and two clew reefs.

• Two Barient 22 STA 2-speed winches for 2:1 mainsheet end boom sheeting system.

• Harken adjustable mainsheet traveler with 4:1 purchase system.

• Three 10" lock-in winch handles.

• Inboard genoa tracks w/ four adjustable jib lead blocks.

• One 8" bow cleat and two 6" stern cleats.

• Lewmar articulated Super-Hatches for forward cabin, head, main cabin, and aft cabin.

• Bowmar opening ports aft with screens for ventilation of main cabin.

• Lexan companionway hatch with lexan two-part drop board plus inside/outside opening, lockable S.S. hasp.

• Double white PVC coated stainless steel lifelines w/ starboard boarding gate.

• Teak flagstaff and 3X5 American flag.

• Molded vertical anchor well designed for Danforth anchor.

Electrical

• Swiveling tulip and R/W dome lights.

• Two Prevailer low maintenance quick charge gelcell deep cycle batteries

• Removeable charcoal formica panels for custom flush mounting of navagation instruments.

• Deluxe Bass electrical panel with backlighting, digital battery condition meter and a full compliment of circuit breakers.

• Bass master battery switch with local 100 amp DC main.

• Navigation lights and combination steaming/foredeck light.

Galley

• One deep polished stainless double sink.

• 2 Burner Origo non-pressurized alcohol stove/oven with stainless safety bar.

• Large 6.0 cubic foot icebox with shelves and divider suitable for reffigerator-freezer option with dual ice box lid.

• Long dry goods storage cabinet with shelf and two

• "drop down" cabinet doors which double as shelves when open. The third door includes inside teak spice rack

• Two utensil drawers w/cabinet under located aft of stove.

• Formica counters tops with cold molded teak fiddles.

• Pot storage under oven and nav. station.

• Trash storage under galley sink with flip lid access.

• Cabinet for cleaning supplies under sink.

Spars and Rigging

• Hall tapered aluminum 6061-T6 alloy section mast with double airfoil spreaders, Awlgrip off white finish, and wire conduits

• Belowdecks mast ventilation holes

• Navtec continuous rod rigging w/Navtec turnbuckles by Hall Rigging Co.

• Hall integral B-12 Quick Vang with 8:1 Harken purchase system.

• Twin crane offshore masthead design.

• Main halyard of 1/4" U19 SS spliced to white 3/8" XLS Dacron braid with Schaefer headboard shackle.

• Genoa halyard of 1/4" 7x19 ss spliced to red code 3/8" XLS Dacron braid with Nicro Fico shackle.

• Two VLS Dacron red code low stretch genoa sheets.

• Traveler control lines of 5/16" VLS Dacron red code braid.

• Mainsheet of white code 3/8" XLS Dacron braid.

• Custom heavy duty stainless chainplates, backstay tang, and stemhead with optional removeable anchor roller.

• Boom w/reefing gear & adjustable outhaul car with 6:1 internal purchase system.

• Two mainsail tack and clew reef lines of red and green code 3/8'VLS Dacron braid.

Interior

• Off white Formica low maintenance bulkheads and furniture panels with cold moulded teak trim and teak drawer and cabinet faces.

• Foam backed vinyl hull siding.

• Varnished teak & holly cabin sole sealed underside with epoxy before installation.

• Private forepeak owner's cabin with 6'6" V-berth with filler section, hanging locker,& storage bin. Superb ventilation from overhead Lewmar articulated hatches.

• Starboard double quarter cabin with hanging locker and changing seat finished with off-white foam backed vinyl.

• Port and Starboard settee berths in main cabin with backrest storage compartments and teak shelves

• Deluxe main cabin cushions with bolsters and choice of interior cushion colors. Sectional cushion arrangement to access storage compartments.

• Forward head with two doors (from forward stateroom and main cabin) including shower, vanity, mirror, and storage. This area contains mast.

• Teak drop-leaf table with teak top and centerline cup holder.

• Large chart table with chart storage and overhead electrical and instrumentation panel suitable for flush mounting.

• Chain/rope locker access in fwd. V-berth.

• Teak and Vinyl deluxe overhead finish throughout main, forward and aft cabins.

Optional Graphic Group

• Two Tone Deck

Optional Comfort Group

• Sunbrella 3" Acrylic Cockpit Cushions.

• 4 Custom Acrylic Covered AC Hose Lifeline Covers for Helmsman.

• Thurston Mainsail Cover with J/35c Emblem.

• Elkhide Wheel Cover for Edson 40" Wheel.

Optional Cruising Group

• Harken Split-Drum Unit 1 Roller Furler

• Thurston Cockpit Dodger

• Transom Swim Ladder

Optional Deluxe Racing Group

• Spinnaker Gear: including Afterguys, Sheets, Hall Spin

• Pole, Pole Chocks, Harken Blocks, Topping Lift, Foreguy,Mast Base Blocks

• 2 Barient Halyard Winches, 3 Halyards, 2 Spinlock Double Stoppers

• Harken Adjustable Genoa/Jib Leads

• Sailtech Integral Hydraulic Backstay

• Checkstay System w/shock cord retreival system.

Optional Deluxe Interior Group

• Overhead Aircraft Bins w/ teak trimmed doors

• Forepeak Bureau Vanity

• Teak Ceilings in Main Cabin

• Bomar BronzeTinted Opening Ports on Cabin Trunk (4).

Other Single Options

• Shoal Draft Keel

• Cradle

• Shrinkwrap

• DC Refrigeration System

• 110 V Shore Power w/o Charger -Cockpit Shower

• Battery Charger

• Cabin Fans

• Hatch & Companionway Screens -Window Shades

Notice:
Specifications subject to change without prior notice or obligation. J/35cs will be constructed with specifications in effect at time of construction. These specifications are effective beginning with J/35c Hull #33 and above. J Boats reserves the right to periodically upgrade these specifications through additions, deletions and substitutions.

(Last Available Model Year 1994)